Table of Contents
Advertisement
REMOTE OPERATION
Power source of infrared remote control unit
The infrared remote control unit is powered by two bat-
teries (size IEC standard R6).
The life of the batteries
is about a year although it depends on the number of
times the unit is used.
Replace the batteries when oper-
ation is not possible or when the distance becomes too
small.
Controls and function
TRANSMISSION
WINDOW
OPERATE:
Same
as OPERATE
on the
T
>
W i l l
f i
VTA:
{Turns Gperata on/otty
RANSMITTING
INDICATOR:
Will light
when any button is pressed, and transmit
commands from the remote control unit to
CLOCK/TIME
DISPLAY:
While
setting
the VTR.
the clock/timer,
this display will prompt
you through the procedure.
After setting
the clock, the display gives you a con-
stant readout of the clock time.
10-KEY BUTTON
¢ Press two numbers to select a channel.
¢ Also uses for setting the clock and pro-
gramming the timer.
CLOCK/TIMER
PROGRAMME
BUT-
TONS: See next page for complete infor-
mation.
CHANNEL:
Same
as CHANNEL
on the
VTR. (Select next higher or lower channel.)
REPEAT:
For repeat function.
See page 18 for details.
REC: Press both buttons to start recording.
F.ADV: Advance the picture from frame to
PLAY/STOP/PAUSE/REW/F.FWD:
:
;
frame during still playback.
See page 17.
Same as on the VTR.
SLOW/S.SPEED/S.TRACKING:
Used for slow motion play.
(See page 18 for details.)
FAST: Used for fast playback. See page 18
for details.
MEMORY:
Same
as MEMORY
on
the
VTR.
(Turns counter memory on/off.)
This button is disable.
RESET:
Same
as
RESET
on
the VTR.
(Resets tape counter to 0000.)
@ HITACHI
22
Advertisement
Table of Contents
