Table of Contents
Advertisement
USING THE REMOTE TO CONTROL
SET-TOP-BOX/SATELLITE
RECEIVER
FUNCTIONS
Operating the precoded function
for your set*top-box/satellite
receiver.
This remote is designed to operate different types of set-top-box/satellite
systems. You must first program the remote to match the
remote command set of your set-top-box/satellite
systems (refer to page 40).
1.
Turn ON your set-top-box/satellite
systems.
2.
Aim the remote control at the front of your set-top-box/satellite
systems.
3.
Press and release the SET-TOP-BOX
(STB) button to switch to set-top-box/satellite
pre-coded mode.
4.
Hold down the STB button on the remote and enter the two digit preset code that matches your set-top-box/satellite
receiver as
shown on page 40. The STB button light will flash 3 times if the code was accepted.
5.
Aim the remote at the set-top-box/satellite
receiver and press the POWER button. The remote will turn off your set-top-box/satel-
lite receiver if the correct two digit preset code is entered.
When this occurs, the remote control is programmed for your set-top-
box/satellite receiver,
if the set-top-box/satellite
receiver does not turn off, try a different two digit preset code.
6.
The remote will now control your set-top-box/satellite
receiver.
NOTES:
1.
If your set-top-box/satellite
receiver cannot be operated
after performing the above
procedures,
your set-top-
box/satellite receiver code has not been precoded into the
remote.
2,
In the
unlikely
event
that
your
set-top-box/satellite
receiver cannot be operated
after performing the above
procedures, please
consult
your
set-top-box/satellite
receiver operating guide.
3,
The remote control will remember
the codes you have
programmed until the batteries are removed
from the
remote control.
After replacing the batteries repeat the
entire programming procedure as stated above.
4.
The ANT button will act as the TV/STB button when in
STB mode.
(_
SET*TOP*BOX (STB) button
This button allows the remote to control your satellite receiv-
er by setting it to SET-TOP-BOX/SATELLITE
mode.
(_
PRECODED
SET-TOP*BOX/SATELLiTE
RECEIVER
but*
tons
These
buttons
transmit
the chosen
precoded
set-top-
box/satellite codes.
(_)
EXCLUSIVE TV buttons
These buttons are for operating the TV.
©®®
MY SATELLITE
RECEIVER/STB
CODE IS:
NOTE:
Refer to instruction
manual of the set-top-box/satellite
receiver for operation of the buttons exclusively for the set-top-
box/satellite receiver.
37
Advertisement
Table of Contents
