Replaceable Parts - HP R85026A Manual

1. Remove the outer and inner covers by performing the Cover Removal under the CABLE
TROUBLESHOOTING section.
2. Unsolder the wires connected to the power cable/circuit board assembly. Note that the pads to which
the wires are soldered are labeled as indicated in Table 4-1.
3. Remove the 1/2 inch hex nut that fastens the cable to the end plate.
4. Remove the old cable.
5. Install the new cable by performing this procedure in reverse order.
OmBUma
INFORMATION
Refer to Table 4-3 for the list of HP R85026A replaceable parts.
If your HP R85026A fails (other than W1), a restored detector is available from your nearest Hewlett-Packard
sales or service office on an exchange basis, thus affording a considerable cost savings.
Exchange (factory repaired and tested) detectors are available ONLY on a trade-in basis. The defective
HP R85026A MUST be returned for credit.
lAELE FARTS
This section contains replaceable parts ordering information. Table 4-2 lists abbreviations used in the parts
list, and throughout this manual. Table 4-3 lists all replaceable parts.
The following information is given for each replaceable part;
• The Hewlett-Packard part number.
® The part number check digit (CD).
® The total quantity (Qty) in the instrument.
® A description of the part.