Table of Contents
Advertisement
EQmPMEHT MdUIRED BUT NOT iUFPLI
To use the HP R85026A detector, you will need a network analyzer and a source.
With the HP 8757A scalar network analyzer, you can make measurements using AC detection (a 27.778 kHz
amplitude modulated signal), or DC detection (an unmodulated signal). The HP 8757A, with up to four
HP R85026A detectors (Opt. 001), measures amplitude levels of -SO to +10 dBm and amplitude ratios
of up to 60 dB (AC detection). For more information, seethe
HP 8757A Scalar Network Analyzer Operation
Manual.
To ensure that the HP R85026A meets its dynamic accuracy specification, the HP 8757A must have
firmware revision 2.0.
There are several source options:
®
The HP 8350B sweep oscillator with an HP 83550A RF plug-in and an HP 83554A mm-wave source
module.
«
The HP 8350B sweep oscillator with an HP 83590 series RF plug-in, an HP 83498 microwave amplifier,
and an HP 83554A mm-wave source module.
® The HP 8350B sweep oscillator with an HP 83572A/B RF plug-in (option 006).
«
The HP 8340A or 8341A synthesized sweeper with an HP 8349B microwave amplifier, and an
HP 83554A mm-wave source module.
Note: The HP 8349B microwave amplifier requires a 0.5V/GHz input from the source. See SOURCE
SYSTEM GUIDES in the
HP 83554A Millimeter-Wave Source Module R-Band System Manual.
The following equipment is available for use with the HP R85026A detector:
HP R752C/D.Directional Coupler (10 dB/20 dB)
HP R532A.Frequency Meter
HP R382A .Precision Variable Attenuator
General Information
1-3
Advertisement
Table of Contents
