Advertisement
•
If you are installing a premium seat on a traction
unit with a standard seat installed, complete the
following procedure:
1.
Park the machine on level ground, shut off
the engine (if equipped), engage the parking
brake, and remove the ignition key.
2.
Remove the 2 flange bolts and nuts securing
the armrest to the seat
fasteners.
Important:
Ensure that you support the
armrest after removing it so that it does
not crimp or hang by the cables and
wires.
1. Armrest
2. Armrest bracket on the
seat
3.
Disconnect the seat wire harness from the
machine wire harness
4.
Remove and discard the 4 nuts securing the
seat rails to the seat pan and remove the
seat
(Figure
3).
1. Seat rail
2. Seat pan
(Figure
2). Save the
Figure 2
3. Flange bolt
(Figure
7).
Figure 3
3. Flange nut (discard)
2
Installing the New Seat
Parts needed for this procedure:
1
Seat assembly
4
Flange nut
1
Short wire harness
2
Cable tie
Procedure
1.
Install the 4 studs on the seat rails into the seat
pan and secure them using 4 flange nuts
4).
Note:
There are 2 installation locations in the
seat pan. For tall operators, install the seat into
the rear holes. For shorter operators, install the
seat into the front holes.
g277238
Front-hole installation shown
1. Seat rail
2. Seat pan
g277240
2
Figure 4
3. Flange nut
(Figure
g277240
Advertisement
