Advertisement
Note:
The eTriflex does not have holes in the
seat pan; if you want to adjust the seat, change
the position of the seat on the seat mount
brackets as shown in
Figure 5
1. Forward hole in the seat
mount bracket
2. Seat mount washer
Important:
Ensure that the seat has full
clearance after adjusting the seat mounting.
2.
Disconnect the right side of the seat bracket
from the seat slide to create clearance for the
console wire harness between the seat bracket
and the seat slide
Note:
You may need to loosen the hardware on
both sides of the seat bracket.
Figure
5.
3. Seat mount bolt
(Figure
6).
3.
Route the console wire harness between the
seat bracket and the seat slide
g285734
1. Seat bracket
2. Seat
4.
Secure the wire harness to the console arm
using cable ties or install the tree clips attached
to the wire harness to the console arm for the
eTriFlex.
5.
Connect the open connector in the main wire
harness (located to the right rear of the seat) to
the short wire harness that came with the seat
(Figure
7).
Premium seat harness shown
1. Open connector on the main wire harness
2. Short wire harness from the kit
3
(Figure
Figure 6
3. Console wire harness
4. Console arm
Figure 7
6).
g278221
g015301
Advertisement
