Sharp FLASH PATH VR-1FPN Operation Manual page 10

Preparation
Inserting (removing) the Batteries in 4 Set the battery cover over the battery, then hold
down and turn it clockwise to fasten it in place.
the FlashPath
{1 Set the FlashPath on a flat surface.
2 Hold down the battery cover and turn it
counterclockwise to remove it.
REPLACE BATTERY WITH TOSHIBA OR HITACHI MAXELL
TYPE CR2016 ONLY. USE OF A DIFFERENT BATTERY MAY
PRESENT A RISK OF FIRE OR EXPLOSION.
MII KEEP THIS BATTERY AWAY FROM
3 Insert (remove) the battery.
|
CHILDREN. IF SWALLOWED, CONSULT A PHYSICIAN
Set the battery with the @ side facing upwards and IMMEDIATELY FOR EMERGENCY TREATMENT.
check that the side of the battery is touching the
electrode in the cover. Check carefully that the oT URTOMIBATTERY MAY EXPLODE IF MISUSED OR
electrode is not underneath the battery INSTALLED WITH POLARITY REVERSED. DO NOT
l RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE.
Battery cover Cautions:
e The lithium battery will not function if installed with the polarity
reversed.
¢ Do not short-circuit, recharge, disassemble, or heat the
battery.
e Should the battery leak, wipe the battery compartment clean,
and then insert a new battery.