Sharp FLASH PATH VR-1FPN Operation Manual page 12

Using the FlashPath
Loading the FlashPath in the Floppy
Disk Drive
{1 Carefully wipe any dirt or dust out of the oblong
hollow at the top center of the rear side of the
FlashPath by using a cotton swab or soft cloth.
2 Load the FlashPath in the FDD.
The FlashPath can now be used in the floppy disk
drive.
e The computer will not recognized the FlashPath if it
is loaded without the SmartMedia.
e To format the SmartMedia, refer to "Formatting the
SmartMedia" on page 10.
3 Remove the FlashPath.
e After removing the FlashPath from the FDD,
carefully wipe any dirt or dust out of the oblong
hollow at the top center of the rear side of the
FlashPath.
e After cleaning the FlashPath, always remove the
SmartMedia and store the FlashPath in its hard
case.
s To extend the service life of the batteries, always
remove the FlashPath from the FDD except when
accessing it.