Cleaning And Care - Fujitsu ASBG18LF User Manual

Table of Contents

Advertisement

10 °C HEAT OPERATION
To use 10 °C HEAT OPERATION
Press the 10 °C HEAT button (Fig.5 H)
The OPERATION indicator lamp (green) (Fig. 3 5 ) will go out, and the ECONOMY
indicator lamp (green) (Fig. 3 7) will light.
To stop 10 °C HEAT OPERATION
Press the START/STOP button (Fig.5 M)
Then the OPERATION stops and the ECONOMY indicator lamp (green) (Fig. 3 7 ) will
go out.
About the 10 °C HEAT Operation
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 10 °C by pressing the 10 °C HEAT button
(Fig.5 H) so as to prevent the room temperature from falling too far.
• In case of multi-type air conditioner, if other indoor unit is used for heating, the tem-
perature of the room where the "10 °C HEAT" function is applied will rise. When using
the "10 °C HEAT" function, we recommend all indoor units should be run under the
"10 °C HEAT" mode
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2 ) more than
3 seconds and less than 10 seconds on the main unit control
panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) once again.
(Controls are located inside the intake grille)

CLEANING AND CARE

CAUTION!
● To avoid excessive wear of the part and components or malfunctioning of the air conditioning, the user/consumer shall perform
preventive maintenance through an accredited technical assistance, periodically. To know the preventive maintenance period-
icity, the consumer shall check with the accredited installer or an accredited technical assistance.
● When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the unit
be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.
● It is recommended for the user/consumer to demand a copy of the Work Order every time there is a visit of a technical assis-
tance for verifi cation, maintenance, test or repair of the product.
● When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like benzene or
thinner.
● Do not expose the unit body to liquid insecticides or hairsprays.
● When shutting down the unit for 1 month or more, fi rst allow the fan mode to operate continuously for half a day to allow inter-
nal parts to dry thoroughly.
● Before cleaning the air conditioner, be sure to turn it off and disconnect the Power Supply Cord.
● Be sure the Intake Grille (Fig. 1 8) is installed securely.
● When removing and replacing the air fi lters, be sure not to touch the heat exchanger, as personal
injury may result.
While 10 °C HEAT OPERATION is in
progress, only the following
operation can be used.
• SET
SET
● Indicator Lamp
OPERATION
TIMER
ECONOMY
: Lighting
: OFF
● When the air conditioner is operated
with the controls on the MANUAL AUTO
button, it will operate under the same
mode as the AUTO mode selected on
the Remote Controller (see page 7).
● The fan speed selected will be "AUTO"
and the thermostat setting will be stan-
dard. (24
°C
)
En-12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asbg24lfAsbg30lf

Table of Contents