Hard copy
Connect a signal to the oscilloscope input.
Output
@
Use AUTOSCALE or set up the oscilloscope to display the input
signal manually.
e
Make some automatic measurements.
This is only to demonstrate the
output.
e
Press SHOW key.
Displays the setup information.
Again this is not required to make
the hardcopy.
e
Press HARDCOPY key ( front panel SYSTEM CONTROL section).
The printer receives a copy of the
oscilloscope display, including the
measurements and setup
information.
HP 54501A, HP 54502A and HP 54503A
Making a Hardcopy Output
Getting Started Guide
7-3