POSITIONNING
•
Install the machine on a flat hard floor. Make
sure that air circulation around the appliance is
not impeded by carpets, rugs etc.
•
Check that the machine does not touch the wall
or other kitchen units.
•
If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a
spanner.
Never place cardboard, wood or
similar materials under the appliance
to compensate for any unevenness in
the floor.
WATER INLET
•
The inlet hose is supplied with the appliance
and can been found inside the appliance drum.
•
Do not use the hose from your previous
appliance to connect to the water supply.
This appliance must be connected toa
cold water supply.
•
Fill the smaller upper
hole and the two large
ones with the plastic
plug caps supplied in
the bag with the User
Manual.
•
Level the appliance by
raising or lowering the
feet.
•
The feet may be tight
to adjust as they in-
corporate a self lock-
ing nut, but the appli-
ance MUST be level
and stable.
•
After having levelled
the appliance, tighten
the lock nuts.
•
Accurate levelling pre-
vents vibration, noise
and displacement of
the appliance during
operation.
45˚
35˚
•
Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tight-
en the ring nut again to prevent leaks.
•
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
WATER DRAINAGE
The end of the drain hose can be positioned in
three ways:
•
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come
unhooked when the appliance is emptying. This
•
Connect the hose
with the angled con-
nection to the ma-
chine. Do not place
the inlet hose down-
wards.
•
Angle the hose to the
left or right depending
on the position of your
water tap.
•
Connect the hose to a
tap with a 3/4"thread.
Always use the hose
supplied with the ap-
pliance.
19