Installing The Grass Basket - Toro Greensmaster eFlex 1021 Operator's Manual

3. Slide a wheel onto an axle
4. Pivot the wheel-locking clip
center of the wheel, allowing it to slide farther
onto the axle.
5. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is
secured in the groove on the axle shaft.
6. Repeat the procedure on the opposite side of
the machine.
7. Carefully lower the machine off the kickstand.

Installing the Grass Basket

Parts Required
1
If you drop the basket, examine the pitch-arm
contact points
basket for damage. Straighten them before
using the basket.
Using the basket with bent pitch-arm contact
points may cause contact between the basket
and cutting unit, causing undesired noise and/
or damage to the basket and cutting unit.
1. Grasp the basket by the handle.
2. Guide the basket lip between the cutting unit side plates and over the front roller.
3460-892A
.
away from
Grass basket
near the lower lip of the
G406965
IMPORTANT
G404688
Page 3–2 Setup: Installing the Grass Basket