2. Rotate the bolt clockwise
clockwise
height adjuster
adjuster should be parallel to the upper
receiver weldment
3. Tighten the nut on the latch bolt so that the
new bolt position is secured against the pivot
stop.
Mounting the Battery Charger
Optional
Parts Required
4
You can mount the charger to a surface using the key holes on the back of the charger; use
screws that have a 1/4-inch diameter shaft and a head diameter less than 11 mm (7/16
inch).
Survey your work area and determine a location that best meets the criteria for safe
and effective operation of the charger.
3460-892A
or counter-
to adjust the angle of the handle-
in or out. The handle-height
.
Screw (1/4 inch with a 7/16 diameter head)—Not included
G440771
IMPORTANT
Page 3–4
Setup: Mounting the Battery Charger