Setting The Communication Mode - Sony RSE-500 Operating Instructions Manual

What's a SPID?
SPIDs are Service Profile Identifiers. SPIDs are used
to identify the ISDN device and allow a large
uniformity for setting the ISDN device with a switcher.
When the system connects to the following types of
network switcher, you can use ISDN lines and will
have to register the SPID.
• AT&T 5ESS
- Network switcher software; 5E8 or later (for
National ISDN-1 and National ISDN-2)
•Northern Telecom (NTl) DMS-100
- Network switcher software: BCS34 or later (for
National ISDN-1 and National ISDN-2)
About custom ISDN
The Vidio Transmitter can communicate with custom
ISDN. In such case, please use the following particular
country codes.
•AT&T 5ESS Multipoint custom 110
• AT&T 5ESS Point to Point custom 112
•Northern Telecom DMS-100 custom 111
3
4
5
Setting the Communication
Mode
When your country or region has a 56 Kbps line rate,
set the ISDN line rate.
When you connect via the V.35 interface, set the
number of channels and line rate.
1
Select 33. COMMUNICATION MODE from the
■SETTING menu.
The following screen appears.
-CDMMUNICnTIDN MODE —
[MQDEi:[S4k1 56K
U35
PORT :|DUPiLl SINGLE
rote: [128 IK
123456
<CANCEL> <DK>
When you connect the remote site via ISDN, select
the line rate for sending and receiving using or
♦, then press ♦.
64K:
via normal ISDN line.
56K:
specific regions or countries with a 56 Kbps
ISDN line rate.
When you connect the remote site via the V.35
interface, select the number of channels using ♦ or
♦, then press ♦.
DUAL: when you use both the CHANNEL A
and B ports of the terminal adaptor.
SINGLE: when you use only the CHANNEL A
port of the terminal adaptor.
Select the line rate of the V.35 interface for
receiving using ♦ or 4
-,
then press ♦.
•When you use both the CHANNEL A and B ports
of the terminal adaptor, set the line rate to 128 K.
• When you only use the CHANNEL A port of the
terminal adaptor, set the line rate between 64 and
384 K.
After entering the line rate, move the cursor to
<OK> using ♦, then press ENTER.
The setting is registered and the SETTING menu
appears.