Specific Safety Rules - Panasonic EY6812 Operating Instructions Manual

13) Do not force tool. Use the correct
tool for your application.
The correct toot wilt do the job better
and safer at the rate for which it is
designed.
14) Do not use toot if switch does not
turn it on or off.
A tool that cannot be controlled with
the switch is dangerous and must be
repaired.
15) Disconnect battery pack from tool
or place the switch in the locked or
off position before making any
adjustments, changing acces¬
sories, or storing the tool.
Such preventive safety measures
reduce the risk of starting the tool acci¬
dentally.
16) Store idle tools out of reach of
chlldrsn and other untrained per¬
sons.
Tools are dangerous in the hands of
untrained users.
17) When battery peck is not In use,
keep it away from other metal
objects like: paper clips, coins,
keys, nails, screws, or other email
metal objects that can make a con¬
nection from one terminal to
another.
Shorting the battery terminals togeth¬
er may cause sparks, bums or a fire.
16) Maintain tools with care. Keep cut¬
ting tools sharp and clean.
Property maintained tools with sharp
cutting edge are less likely to bind
and are easier to control.
19) Check for misalignment or binding
of moving parts, breakage of parte,
and any other condition that may
affect the tool's operations. If dam¬
aged, have the tool serviced before
using.
Many accidents are caused by poorly
maintained tools.
20) Uas only accessories that are rec¬
ommended by the manufacturer
for your model.
Accessories that may be suitable for
one toot may create a risk of injury
when used on another too).
Service
21) Tool service mutt be performed
only by qualified repair personnel.
Service or maintenance performed by
v unqualified personnel may result in a
risk of injury.
22) When servicing a tool, use only
identical replacement parts. Follow
instructions In the Maintenance
section of this manual.
Use of unauthorized parts or failure to
follow Maintenance Instructions may
create a risk of shock or injury.
SPECIFIC SAFE¬
TY RULES
1) Hold tool by Insulated gripping
surfaces when performing an
operation where the cutting tool
may contact hidden wiring.
Contact with a "live" wire will make
exposed metal parts of the tool live"
and shock the operator.
2) Wear ear protectors when using
the tool for extended periods.
Prolonged exposure to high intensity
noise can cause hearing loss.
3) Be aware that this tool Is always In
an operating condition,
it does not
have to be plugged into an electrical
outlet.
4) Do not operate the reverting lever
when the main switch is on.
The battery will discharge rapidly and
damage to the unit may occur.
5) If ths bit becomes Jammed, imme¬
diately turn the main switch off to
prsvsnt an overload which can
damage the battery pack or motor.
Use reverse motion to loosen
Jammed bits.
6) When storing or carrying the tool,
set the reversing lever to the cen¬
ter (switch lock) position.
7) Do not strain ths tool by holding
the speed control trigger halfway
(spaed control mode) so that ths
motor stops.