Operation - Panasonic EY6812 Operating Instructions Manual

Operation
(§) Chuck
Note: Grease for bits
Grease the oval indentation on
the bit with the supplied grease
at least once a month.
1. Align the oval uneven parts of the
bit with the marks on the chuck as
shown.
2. Turn the chuck counterclockwise.
Insert the bit to the chuck as far as
it will go.
3. Release the chuck when the bit is
inserted completely.
(The chuck goes back automati¬
cally and the bit is fixed.)
4. Make sure that the bit is fixed by
pulling it.
Type A
Type B
5. To remove the bit, turn the chuck
counterclockwise, and pull the bit.
® Reversing lever
Be sure to set the switch in the center to
lock it after use.
© Hammering/drilling switching
lever
Selecting action mode
Position ol
switching lever
Action mode
Material
Concrete
T
hammering
mortar,
brick, ate:
Rotation
only
Tile, etc.
Note: Use drill mode when work with
fragile materials like tile, etc.
® Trigger
To set the center of a hole, puli the
trigger slightly to start the drill rotating
slowly.
-7-