Kenwood 1050MD Instruction Manual page 11

System connections
1Q50M0 lE"^'
About the system control connections
11
About the system control connections
Connecting system control cords after connecting a Kenwood audio component system lets you take advantage of
convenient system control operations.
There are two Kenwoood system control modes. Make connections according to the groups of terminal symbols shown
below.
[XS8] Mode : lets you combine
DCL,
KS.,
and
XS8
terminals
[SL16] Mode : for [SL16] terminals only
This unit is SLTB compatible.
You can connect this unit via system control if all other equipment using system control connections are set to the [SL16]
mode.
1. ISL161 eau'Dr^en: cannot De comoinen wtn [XRj, [XS], ana [XS81 eauipnient to'' system
operat ors if your eau^prrent consists of rnis <ina of combination, oiease do not connect
any system control cmds. Even without system control coros. normal c.nerations can oe
carrieo out wtnout aftect'ng oerfcmiance.
2 d your amp o' receiver does not nave a system control termna', do not connect any syste^''.
control cords to the system cont'ol terminals on the other coriiponents.
3 Do not connect system cont'ol corns to any comoonents otne'' than those specifiea by
Kenwood
U may
cause a maifunct on ana oamage you'' equioment
4. Be sure the system control plugs am insedec a' the way in to the system control terminals
r-^---—-—----—_—
About the system control operations
Remote Control
Lets you operate this unit with the system remote supplied with the amp or receiver.
Automatic Operation
Automatically switches the input selector on the amp or receiver when you start playback from this unit.
Synchronized Recording
When recording a CD after setting the amplifier's input selector to CD, starting playback on the CD player allows to
start recording automatically in an interlocked operation.
• Do nci operate me CD olayer during recording of a cigital soume other tnan CD. otnerwise malfunction may
occur, -.30,
V-—____ - _____ "_ J
Note on connection of optical-fiber cable
The optical-fiber cable is designed for use in the connection
of the CD player (optional). The digital signal transmission
makes it possible to record the high-quality sound of CDs
without degradation.
• Insert the optical-fiber cable straight 'nto tne connector until it clicks.
• Be sure to attach the protection cap when tne connector is not used.
• Never oend m Dundle the ooticaMiber cable,
• Ai! of the commercially-avaiiable optical fiber cables cannot be used
with these 'units. If there is an optical fiber cable which cannot be
connected to your component, please consult your dealer or nearest
KENWOOD agent.