Kenwood 1050MD Instruction Manual page 29

Recording (DlGiTAL input)
Enter record-pause mode..
Start recording.
Play the source to be recorded.
After recording, eject the Mini Disc.
• Tne i.n t e^'e's "src'a-Dft.-se ''^oce clj:q'"3: .:a \ A- e- " t- • -
■
D^essec
Recora ng s noi possin e * ine 'oiiow "c craractefs a'e a sciave'D
"DISC FULL"
"001 UNLOCK"
"001 SCMS ON"
"001 notAudio"
"PROTECTED"
"PLAY ONLY"
D sc is fu!!
^ Erase unaes -ed t'aC'^s -..JC. - ._42_
Tne oigiiaiccra01 opt cal fipe'caoie snot ocKeo
in positic'. O' connectea incon'picTOiv lor no;
ccnnec*ed'
^ Connect tne digita core o' octica f oe caoie
proper v -* Jo.
D g ta' recora no s inhipiied oy SCMS
Use analog 'ecc'ding -
Tho dig'ta signa' bo ng inout is no: an aad'O
signe
^ Use analog recora^ng -"..-^6
The acc aentai eras^/e protect tab is coe''.
^ C ose it - .„f_
The disc in use is a p aypacK-omy Mmi D sc
^ Use a recoraaoie Mmi Disc. —
• When The EDIT / SPACE key IS O'essec dunnn recording, a track
nun'ber s mserteo m that posiLion
• The track number display (001 in tne above) indicates tne track where
tne s put to reco'd-oause n-oae
• VVnen
'ecQ'ding is restarted a'tc' record-pause, tne tracr. numper ts
mc'errientea automatica"y by "1".
• To play a back w tn a margin f'^om the beginmnc, it is recommended to
sta't clay ng the source a+ter the time a solay of t^e MD reco'de' has
sta'tec the count.
l'''o:n;;i!ior- is tvir" Disc nas oee"- e'tjctec
ne r'o vv' rter
• The eject (4t.i -rey is no; accepted during recording
While "WRITING" is displayed, do not apply shock
or vibration to the unit because information is
being written on the Mini Disc.
Durmg 'ecoming ot a CD. me t^'ack '^„mber may be incremented oy "1 ' at the rmoment rne CD starts to play. This is caused by a signal
conta ned r the dig;ta signa comco'-e^t of tne CD. Unnecessary bac< numoers can oe erased by tollovying the procedure tor "Erasing the
track being played (TRACK ERASE). ^ -iQ