Husqvarna EPOS RS1 Operator's Manual page 11

EPOS Support by wire
3.9.4 To use the
function
The boundary wire can be installed to operate with the
EPOS system. Install the boundary wire if the satellite
signals are weak. It can be in a part of the work area or
an area where you have installed a transport path. Refer
to the operator's manual for the robotic lawn mower on
how to install the boundary wire.
Note:
Do not use the boundary wire to extend the
work area.
• Put a part of the boundary wire (A) approximately 2
m / 6.6 ft from the area where the satellite signal is
weak.
A
2211 - 002 - 30.11.2023
EPOS Support by wire function when
• Enable the
the boundary wire is installed. Select
EPOS Support by wire > Enable in the
>
®
Automower Connect app.
• Extend the boundary wire in the work area if the
product continues to stop in a part of the work
area.
• Extend the boundary wire in the work area if the
product cannot move from the area with boundary
wire.
3.10 To install the product
™
1. Install the EPOS Plug-in. Refer to
EPOS plug-in on page 11 .
®
2. Install the Automower
mobile device. Refer to
page 12 .
3. Do a pairing operation of the product and the
®
Automower Connect app. Do the EPOS
in the Automower ® Connect app. Refer to
the EPOS ™ setup on page 11 .
4. Install the charging station. Refer to
charging station on page 12 .
5. Install the reference station. Refer to
the reference station on page 13 .
6. Make a map with work areas, stay-out zones,
transport paths and maintenance points. Refer to
Installation of the map objects on page 15 .
®
7. Use Automower Connect app to do settings for
Automower
the product. Refer to
page 12 .
Note:
For more information about settings in the
app, read the Operator's manual for the robotic
lawn mower.
3.10.1 To install the EPOS plug-in
Follow the instructions for installation in the operator's
®
manual for Automower EPOS
3.10.2 To do the EPOS
When the product is set to ON for the first time, there
are some basic settings to do before the product can
start to operate. You must do a pairing operation of
the product and the Automower
objects on the map, change the settings and operate
the product. Use the Automower
mobile device or on the Automower
1. Set the product to ON.
Note:
®
The Bluetooth
of the product is enabled for 3 minutes. If the
pairing operation between the product and the
mobile device is not completed in 3 minutes, set
the product to OFF and then set the product to ON.
Accessories
To install the
Connect app on your
®
Automower Connect on
™
setup
To do
To install the
Installation of
®
Connect on
™
Plug-in.
™
setup
®
Connect app to install
®
Connect app on your
®
Connect app.
pairing operation mode
Installation - 11