Installation - Husqvarna EPOS RS1 Operator's Manual

Note:
Other symbols/decals on the product refer to
certification requirements for some markets.
2.1.7 Symbols in the app
Shows the strength of the radio signal that
the product receives from the reference
station.
EPOS confirmed . The
The status is
product has an accurate position and
direction. This is necessary to operate
the product automatically and for the
installation of map objects.
3.1 Introduction - Installation
WARNING:
safety chapter before you install the product.
WARNING:
safety chapter in the manual for the robotic
lawn mower before you install the product.
CAUTION:
Use original spare parts and
installation material.
Note:
Refer to www.husqvarna.com for more
information about installation.
3.2 Primary components for installation
The installation includes the components that follow:
6
• Robotic lawn mower , that cuts the lawn
automatically.
7
• Charging station , that charges the product.
8
• Power supply unit , which is connected to the
charging station and a 100-240V power outlet.
• Power supply unit, which is connected to the
reference station and a 100-240V power outlet.
• Reference station, that receives satellite signals
and sends correction data to the robotic lawn
mower.
6
Purchased separately.
7
Purchased separately.
8
Included with the charging station.
9
Purchased separately.

6 - Installation

3 Installation
Read and understand the
Read and understand the
EPOS action is necessary .
The status is
The product has an accurate position but
it is necessary to operate the product,
manually or automatically, to get an
accurate direction.
EPOS searching . The
The status is
product does not have an accurate
position and is searching for the satellite
signals and the correction data to get an
accurate position.
® ™
• Automower EPOS Plug-in
• Mobile device with the Automower
to do the installation and the settings for the
product.
3.3 To prepare for installation
CAUTION:
Holes with water in the lawn
can cause damage to the product.
CAUTION:
Read the installation
chapter before you start the installation.
• Make a blueprint of the work area and include all
obstacles. This makes it easier to examine where
to put the charging station, the reference station,
and the virtual boundaries.
• Make a mark on the blueprint where to put
the charging station, the reference station, the
maintenance point, the transport paths and the
virtual boundaries for the work areas and stay-out
zones.
• Follow the instructions for distances between
obscuring objects.
• Fill in holes in the lawn to make it level.
• Cut the grass before you install the product. Make
sure that the grass is maximum 10 cm / 4 in.
9
.
®
Connect app
2211 - 002 - 30.11.2023