Husqvarna EPOS RS1 Operator's Manual page 15

5. Install the cable cover.
6. Connect the low-voltage cable from the reference
station to the power supply.
7. Attach the low-voltage cable to the wall or pole with
cable ties.
CAUTION:
cable is not attached tightly with cable
ties, it can become damaged in hard
wind.
8. Put the power supply 30-200 cm / 1-6.5 ft. above
the ground. Refer to To examine where to put the
power supply on page 7 .
9. Connect the power supply cable to a 100-240V
power outlet.
Note:
The LED indicator of the reference station
flashes green for some minutes. The LED indicator is
solid green when the reference station is in operation.
LED indicator lamp on the reference station on
Refer to
page 23 .
3.10.6 Installation of the map objects
Read and understand the instructions about where to
install the map objects. Refer to
install the virtual boundaries on page 9 .
On the map you can install the objects that follow in the
app:
Work areas (A)
•
• Stay-out zones (B)
Transport path (C)
•
Charging station (D)
•
Maintenance point (E)
•
• Reference station (F)
Work area (Secondary area) (G)
•
2211 - 002 - 30.11.2023
If the low-voltage
For a complete map installation, you must install a work
area and a charging station on the map.
A work area is specified by virtual boundaries. Maximum
work areas and secondary areas can be installed on a
map.
There are two types of work areas:
•
•
To examine where to
A transport path is a specified path between the docking
point in front of the charging station and a work area.
The product can operate automatically in this path, but
does not cut grass. A transport path can temporarily be
enabled and disabled in the app.
Stay-out zones can be made if there are areas where
the product must not operate. A stay-out zone is
specified by virtual boundaries. Stay-out zones can
temporarily be enabled and disabled in the app.
A maintenance point is a specified position where the
product can be parked at. This can for example be used
for a service point where maintenance of the product
is done. The maintenance point is connected to the
docking point with a path.
A
B
C
E
A
A work area that has a charging station in it or
connected to it with a transport path where the
product operates automatically.
A secondary area is a work area with no charging
station and no transport path. The product must be
moved manually to and from the work area.
G
F
D
Installation - 15