NEC MultiSync 3D JC-1404HME Service Manual page 11

·.::·
..
Shield Case
SUB PWB UNIT
Screw "b" Screw "b" Screw "c"
Band
Anode Cap
Screw "b"
4. Remove the four screws "b" the shield case
and remove the shield case.
5. Remove the two screws "c".
Remove the three screws
"b"
of the SUB
PWB UNIT and the screw "b" (under the
shield case).
Remove the two screws "d".
Screw "d" 6. Disconnect the connectors "CN-A", "CN-M"
and "CN-S". (from SUB PWB UNIT).
Disconnect the connectors "CN-V" (from
CRT PWB ASSY) and lift up the SUB PWB
UNIT.
Screw "b"
Screw "b"
-10 -
7. Remove the two screws "c".
Remove the two screws "d".
Remove the two screws "b" of the SW.
REG. UNIT and the two screws "b" (under
the shield case).
8. Disconnect the connector "CN-K" (from
MAIN PWB ASSY).
Cut the two bands and disconnect the
connectors "CN-SW" and "CN-Z" (from
SW.REG. UNIT).
Lift up the SW. REG. UNIT.