NEC MultiSync 3D JC-1404HME Service Manual page 6

0
COLOR SWITCH
When the monitor receives a TTL color video signal, one of the four color
configurations (AUTO, 8, 16, 64) must be selected.
COLOR SWITCH COLOR MODE
Auto IBM CGA, EGA or Compatible Graphics adapter
8
8 Colors
16
16 Colors with IBM Brown
64 64 Colors
This switch works with preset TTL modes that the monitor identifies automatically.
0
MODE SWITCH
This switch selects either the monochrome mode or color mode with a TTL video
signal input.
With an Analog video signal input and MODE SWITCH ON, the monitor will give
the user an additional user programmable memory area.
MODE Input Video
MODE
SWITCH Signal
TTL General Color Mode (CGA, EGA)
OFF
ANALOG General Analog Mode (VGA, PGC, etc)
TTL
Monochrome Mode (MDA)
ON
ANALOG
User Programmable Memory Area
For more detail, see the signal identification flowchart.
0
H. SIZE CONTROL
8
Adjust these controls for the preferred horizontal size of the display
fj
H. POSITION CONTROL
(g)
Adjust these controls for the proper horizontal position of the display.
e)
V. SIZE CONTROL
(I)
Adjust these controls for the vertical size of display preferred.
0
V. POSITION CONTROL
(9
Adjust these controls for the proper vertical position of the display.
A few seconds after the user adjust the size and/or the position, the monitor's
CPU will save the new control data into it's memory automatically.
NOTE: The monitor will display the screen configuration that was saved last.
4D) MEMORY RECALL BUTTON
.
This button resets the data of user changeable memory and recalls the factory
preset data.
.. ,,r,.n, :,
. ! ,
~.I
-5-
ii''•
,,'i1 1
':,,,,! .