Location; Electricity Supply - Zanussi ZF 67/44 Instructions For Use And Care Manual

Location
Place the appliance as far away as
possible from sources of heat, e.g.
radiators, heaters, direct sunlight, etc.
The best results are achieved with a
room temperature of between +16°C and
+32°C (class N) or between +18°C and
+43°C (class T).
Make sure that there is nothing
hindering air circulation at the back,
bottom, or top of the appliance.
To achieve the best performance, the top
of the appliance — if set under a wall
cabinet — should be at least 100 mm
away from the base of the cabinet
ure 2/A).
However, the appliance should ideally not
be installed underneath wall cabinets (as
shown in Figure 2/B).
One or more adjustable feet mounted on
the base of the appliance make it
possible to set it perfectly level.
In the case of models with a stainless-
steel finish, remove the protective film
from the outer surfaces before use.
Electricity Supply
The appliance is for operation on a
220/240 V 50 Hz supply, so be sure that
your electricity supply voltage is within
the range marked on the nameplate
located inside the cabinet.
Earthing
WARNING: THIS APPLIANCE MUST
BE EARTHED. The manufacturer
declines any liability should this safety
measure not be observed.
If the plug that is fitted to your
appliance is not suitable for your socket
outlet, it must be cut off and the
appropriate plug fitted. The cut off plug
should be disposed of to prevent the
hazard of electric shocks in case it
should be plugged into a 13 Amp socket
in another part of your home.
Electrical connection
IMPORTANT: The wires in this mains
lead are coloured in accordance with the
following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter «E» or the earth
symbol +, or coloured green, or green
and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
«L» or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement use
a 13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced
in the event of changing fuse.
5