Toro Z Master Professional 6000 Series Operator's Manual page 15

Blade-control Switch (PTO)
The blade-control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades,
push the blade-control switch (PTO) down or move a
motion-control lever into the neutral-lock position.
Ignition Switch
This switch is used to start the mower engine and has 3
positions: Start, Run, and Off.
Motion-control Levers
The motion-control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral-lock Position
The neutral-lock position is used with the safety-interlock
system to engage and to determine neutral position.
Fuel-shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
High-oil Temperature Indicator Light
This is the malfunction-indicator light found on the left side
(Figure 5).
If the engine-oil temperature rises above the safe level,
the light illuminates, the engine automatically reduces the
rpm, and the machine will remain in a safe mode until the
corrective action is taken; refer to Troubleshooting (page 66).
Low-oil Pressure Indicator Light
This is the middle malfunction-indicator light (Figure 5).
If the engine-oil pressure drops below a safe level, this light
illuminates, the engine automatically reduces the rpm, and the
machine will remain in a safe mode until the corrective action
is taken; refer to Troubleshooting (page 66).
Electronic-control Unit
Malfunction-indicator Light
The electronic-control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated.
The MIL is found on the right side of the control panel
(Figure 5).
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Troubleshooting (page 66).
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
15