Excluding Certain Channels From Aux Sends (Mix Minus); Copying Channel Fader Positions To Aux Sends - Yamaha 02R96 Owner's Manual

104
Chapter 10—Aux Sends

Excluding Certain Channels from Aux Sends (Mix Minus)

You can quickly exclude certain channel signals from Aux Sends by using the controls on
the top panel. This operation is called "Mix Minus."
For example, when Aux Sends are being used as monitors for the musicians or a narrator,
you can turn off the audio signals of the musicians or narrator, excluding them from the
monitor sound.
Press and hold down the AUX SELECT [AUX 1]–[AUX 8] buttons of the desired
1
Aux Sends.
The [ON] button indicators in the channel strip remain lit while you hold down the button.
This means that signals routed from channels with a lit [ON] button indicator to the Aux
Send are turned on.
Note: If you release the AUX SELECT button before you proceed to Step 2, you will be unable
to complete the Mix Minus operation.
Press the [ON] buttons of the Input Channels you wish to exclude from the
2
Aux Send. You can select multiple channels.
The selected channels' [ON] button indicators turn off, and signals routed from those
channels to the corresponding Aux Send are turned off. "MIX MINUS FOR AUX * "
appears at the bottom of the screen. (The asterisk represents an Aux number.)
Tip: At this time, the Send Level controls on the Aux Send page are grayed out.
To reset the setting, while pressing and holding down the AUX SELECT
3
[AUX 1]–[AUX 8] buttons you pressed in Step 1, press the [ON] buttons you
pressed in Step 2.
The corresponding [ON] button indicators light up.

Copying Channel Fader Positions to Aux Sends

While Aux Sends are in Variable mode, you can copy all Input Channel fader positions on
one layer to the corresponding Aux Sends.
This is convenient when you wish to send to the musicians monitor signals that have the
same balance setting as the Stereo Out signals.
1 Locate the copy source layer button from the Input Channel Layer buttons,
then press and hold down the button.
Note: If you release the button in the LAYER section before you proceed to Step 2, you will be
unable to complete the Copy operation.
2 Press one of the AUX SELECT [AUX 1]–[AUX 8] buttons to select the desired
Aux Send copy destination.
The confirmation message appears.
02R96 Version 2—Owner's Manual