Selecting Fader Modes - Yamaha 02R96 Owner's Manual

Auto Channel Select & Touch Sense Select
While the Auto Channel Select preference is on (see page 230), channels can be selected by
moving the corresponding fader or Encoder, or by turning on the corresponding [AUTO],
[SOLO], or [ON] button. Note that you can use the [AUTO] buttons to select channels only
during Automix recording or in Automix record ready mode.
While the Fader Touch Sense SELECT preference is on (see page 232), channels can be
selected simply by touching the fader knobs.

Selecting Fader Modes

The exact function of each fader depends on the selected Layer and Fader mode.
Select a Layer, as explained on page 47.
1
Use the FADER MODE buttons to select a Fader mode.
2
[FADER]: Channel faders control Input Channel levels or Output Channel master levels,
depending on the selected Layer.
[AUX]: Channel faders control Aux Send levels, depending on the selected Layer.
The indicator of the currently selected FADER MODE button lights up.
The following table shows the channel fader functions for each Layer and Fader mode.
Layer
1–24
25–48
Master
Remote
FADER MODE
Fader
Mode
1–8
Fader
Aux
Fader
Aux
Input Channels 49–56
Fader
level
Input Channels 49–56
Aux
Aux Send level
Fader
See "About the Remote Layer" on page 219 for more information.
Aux
Selecting Fader Modes
FADER AUX
Fader
9–16
Input Channels 1–24 level
Input Channels 1–24 Aux Send level
Input Channels 25–48 level
Input Channels 25–48 Aux Send level
Aux Sends 1–8 master
level
No operation: faders fixed at –∞
Operation depends on the selected target.
02R96 Version 2—Owner's Manual
49
17–24
Bus Outs 1–8 master
level