Table of Contents
Advertisement
2.
Remove the 10 Phillips M2.0 × 3.0 screws that secure the system board to the computer.
3.
Lift the left side of the system board up, and then remove the board from the computer.
4.
When replacing the system board, be sure to remove the USB bracket from the old system board
and install it onto the new system board. To remove the system board bracket, remove the Phillips
M2.0 × 3.0 screw (1), and then slide the bracket (2) off the system board.
To install the system board, reverse this procedure.
46
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
