Table of Contents
Advertisement
h.
To install the camera module, connect the cable (1) to the module, and then place the module
(2) onto the top of the display rear cover.
12.
To remove the camera/touch control board cable:
a.
Peel the camera cable (1) off the top and middle of the inside of the display rear cover.
b.
Remove the cable from the clips (2) along the bottom of the display rear cover.
c.
Disconnect the cable from the touch control board (3) on the bottom of the display rear cover.
The camera/touch control board cable is available as spare part number N87223-001
13.
To remove the touch control board:
a.
Lift the board (1) to release it from the display.
b.
Peel the thin piece of conductive tape (2) off the board.
c.
Disconnect the narrow cable from the ZIF connector (3) on the board.
54
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
