Rear Panel Controls - Kenwood TS-700A Operating Manual

S)
3-2. Rear Panel Controls
@ ANT Terminal
For connection of antenna.
@ NAME PLATE
TS-700A serial number is marked on this plate.
@ TRANSISTOR PROTECTIVE COVER
The transistors in the AVR circuit for 11V and 20V lines are
protected by this cover. The cover also functions as a heat
sink for the transistors.
@ HEAT SINK (FOR TRANSMITTER FINAL STAGE)
For protection of transistors from overheating.
® RL-MAKE TERMINAL (RELAY TERMINAL)
This terminal should be OFF during reception, and should be
grounded during transmission.
© KEY JACK
This jack is used for operating the transceiver in CW mode.
Connect an external telegraphic key device.
@ ALC-INPUT TERMINAL
External ALC terminal.
Ky ext.sP
@)
© 8)
o WS | C7]
RL ALC.
MAKE = INPUT
mm)
K
e
120v. _220V
@
@® EXT SP TERMINAL
For connection of an external speaker.
@ POWER CORD JACK
For connection of the supplied AC power cord (or DC power
cord).
() AC FUSE HOLDER
For AC power fuse (primary), 120V/2A or 220V/1A.
@) VOX SOCKET
11