Kenwood TS-700A Operating Manual page 26

SYMPTOM POSSIBLE CAUSES
—
REMEDY
No or little AM output
1. AM carrier VR is in the minimum
position.
1. Adjust AM carrier VR for suitable
output by turning it clockwise
(about "5" position on the RF
meter).
Incoming signal is not attenuated
at the ON position of CAL knob.
. Absence of 9-pin MT plug in VOX
socket.
. Fit the MT plug to the socket.
No output in SSB mode. . Microphone plug is improperly con-
nected into the microphone jack.
2. SSB mic volume (MIC 2) is set too
low.
. Firmly connect the microphone
plug.
2. Turn clockwise MIC 2 volume in
transceiver.
26
FM mode.
Too small a modulation factor in
. FM mic volume (MIC 1) is set too
low.
. Turn clockwise MIC 1 volume in
transceiver.