Kenwood TS-700A Operating Manual page 15

Set STANDBY switch to SEND
Turn these knobs
for adjustment
Antenna
Adjust for maximum deflection
of meter.
ORIVE
©
©
FINAL
€@©
©
IPOWER SEND
REC
MODE
© Ae
TA
©
CW MODE
If key device is connected, the key
must be in the down position. Ls
PTT (push-to-talk) Operation
To read correct frequencies, the MAIN dial must be
calibrated previously by using the 100 kHz marker unit built
in the transceiver. The marker unit is operative when
SQUELCH knob is turned fully counterclockwise and CAL
switch is set toON. During the operation of the marker unit,
the higher harmonics can be received over the entire band
exactly at 100 kHz intervals. In this instance, the RF input
circuit (relay) is deenergized and, therefore, external waves
are scarcely received.
AM CAR Knob
FM MIC GAIN
SSB MIC GAIN
Frequency Calibration for USB
Fig. 9-a).
Frequency Calibration for LSB
be
SQUELCH KNOB
PSL EN
LsB 4 vse
(a)USB (b) LSB