Makita RM350D Setup Manual page 20

NOTICE: Check that the boundary wires are connected to the proper terminals. If the boundary wires are connected to the wrong terminals,
the Robotic Mower will be unable to recognize the work area.
L
R
Fig.28
► 1. Boundary wire 2. Work area
Connecting the guide wire
Pass the guide wire through the right-side or left-side hooks (two places) and attach the connector at the tip of the wire to the terminal G1 or G2.
NOTICE: To prevent the connector from being deformed or damaged, connect the connector straight without tilting it.
NOTE: The guide wire connector can be attached to either terminal G1 or G2.
Fig.29
► 1. Guide wire connector 2. Terminal G2 3. Right-side hooks (two places) 4. Notch (Do not pass the guide wire through here)
NOTE: If there is a second guide wire, connect it to the open terminal G1 or G2 by the same procedure.
1 2
L R
R
L
2
R
L
3
20 ENGLISH
1 2
L R
L
R
1
4