Pioneer ERV035AVTTW5W Owner's Manual page 9

Operation
MASTER-SLAVE UNIT SETTINGS
Master Unit Settings
Connect the device to power. In the OFF state, as shown in the figure, press and hold the fan
speed button of the unit for 5 seconds, and the status indicator blue light flashes slowly.
Once done, the device enters master-slave linkage mode, and is set to the master role.
The right side blue light will start slowly flashing
Master unit
Slave unit
15
Operation
Slave Unit Settings
1. Connect the device to power. In the OFF state, as shown in the figure, press and hold the mode
button of the device for 5 seconds, and the status indicator green light will start flashing slowly.
Once done, the device enters master-slave linkage mode, and the unit is set to the slave role.
2. During the master and slave set pairing mode, it must be carried out at the same time
inside a limited time (within 1 minute). The devices should be as close as possible. The devices
will be automatically connected.
3. The status light of the paired devices will change to blue light ON to indicate that the
master-slave pairing is successful.
4. If the master-slave pairing fails, the status lights on the devices will flash for one
minute and before the lights turn off automatically.
Slave unit
Master unit
MASTER-SLAVE RESET AND CANCELLATION
Connect the device to power. In the OFF state, long press the fan speed button of the
linked device for 5 seconds, and the device status indicator blue light will start flashing slowly.
At this time, the linked device enters master-slave linkage mode, and the device defaults to
the master role. It should be carried out at the same time inside a limited time (within 1 minute).
Wait for the status indicator lights to come off automatically, whereby the device disconnects from
the slave to break off the master-slave pairing automatically. At this stage, the device is reset
and restored to the factory state, without any role definition.
The right side green light will start slowly flashing
16