Troubleshooting - Silvercrest SLE 200 B2 Operating Instructions Manual

Troubleshooting

The following table will help you to identify and rectify minor malfunctions.
If the solutions below do not resolve the problem, please contact Customer
Service (see section Service).
Fault
The appliance
will not switch
on.
The appliance
stops occasion-
ally (the fan
switches off).
The appliance
is producing
no or too little
condensate.
The air ejected
is warm.
The error code
E 1 flashes on
the display
■ 20 │ GB │ IE
Possible cause
w
The plug is not plugged
in.
The mains power socket is
not supplying power.
Safety stop due to missing
or incorrectly inserted
4
water tank
4
The water tank
The automatic defrosting
function is activated.
The humidity of the room
has reached the desired
level.
The air inlet (air inlet grille
2
) or air outlet
ings are contaminated or
blocked.
The room's windows and
doors are open.
Heat exchange process
Temperature sensor error/
humidity sensor error
p
Remedy
Insert the plug
mains power socket.
Check the house mains fuse.
Insert the water tank
correctly.
Empty the water tank
is full.
reinsert it.
This is a normal feature of the
appliance.
This is a normal feature of the
appliance.
Ensure that the air inlet (air inlet
8 2
open- grille ) and air outlet
openings are clean and free of
obstructions.
Close the windows and doors.
This is a normal feature of the
appliance.
Contact the Customer Service
department (see section
Service).
w
into the
4
4
and
8
SLE 200 B2