Handling And Use; Switching The Appliance On/Off - Silvercrest SLE 200 B2 Operating Instructions Manual

Handling and use

Switching the appliance on/off
♦ Press the
You will hear a beep and the
the
♦ Press the
You will hear a beep and the
the
Note
► The appliance always starts up with the last-selected setting.
► If the appliance shuts down due to a power failure, it will automatically
restart with the last–selected setting when power is restored.
♦ If a timer has been programmed, the appliance switches off permanently
after the specified time has elapsed (1–24 hours).
♦ If the relative humidity value has been set in the
program, the appliance switches off as soon as the value is reached. If the
value is exceeded, the appliance switches back on again.
♦ When the water tank
fan continues to run for approx. 3 minutes and then switches off. If the
water tank
WATER TANK FULL
beep for approx. 20 seconds.
Note
► The water tank
the condensation water cannot be properly collected.
SLE 200 B2
STANDBY button
DRY LAUNDRY LED
STANDBY button
DRY LAUNDRY LED
4
is full or removed, dehumidification stops. The
4
has been removed or is not correctly inserted, the
o
lights up. If switched on, the appliance will also
4
must be completely inserted into the appliance, otherwise
s to switch on the appliance.
DEHUMIDIFICATION LED
t lights up permanently.
s
to switch off the appliance.
DEHUMIDIFICATION LED
t
goes out.
r or
r
or
DEHUMIDIFICATION
GB │ IE │ 13 ■