Electric Heater - Haier MVAX009ME2AA1 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

Electric Heater

The air handlers listed in this manual do not have a factory installed electric heater. An electric heat kit is available as an
accessory. Please refer to installation instructions provided with heater kit for the correct installation procedure.
1. Ensure that all power supply is disconnected prior to installing the heater kit.
2. A means of strain relief and conductor protection must be provided at the supply wire entrance into cabinet.
3. Only use copper conductors.
4. Installation must follow national electric code and other applicable codes.
5. If this appliance is installed in an enclosed area such as a garage or utility room with any carbon monoxide producing
appliance, ensure the area is properly ventilated to the outside.
6. A filter dryer is recommended for installation based on nominal tonnage.
- Refer to the Table below for the appropriate optional heater kit.
- Check for any physical damage; do not install damaged heater kit.
- Remove the upper access panel from air handler.
- Remove cover plate from air handler.
- Slide the heater kit into the slot and secure element plate with previously removed screws.
- Insert power leads into the circuit breaker lugs or stripped red and black wires (for heater kit without circuit breaker)
and tighten.
- Connect ground wire to ground lug.
- Break out appropriate area of the plastic circuit breaker cover on the access panel of the air handler. Knock off the
holes according to the actual installation number and circuit breaker positions. If a circuit breaker is not installed, do
not knock off the holes; otherwise, electric shock may occur.
- Replace access panel and check operation.
- Connect power cords and thermostat wires.
The only heater kits that can be used are UAZEH series on the following page
Machine Model
MVAX009ME2AA
MVAX012ME2AA
MVAX018ME2AA
MVAX024ME2AA
MVAX030ME2AA
MVAX036ME2AA
MVAX042ME2AA
MVAX048ME2AA
MVAX054ME2AA
MVAX060ME2AA
20
Cover Plate
Bolt
Heater Kit
Circuit Breaker
Matched Heating Model
UAZEH05A/08A/10A
UAZEH05A/08A/10A
UAZEH05A/08A/10A
UAZEH05A/08A/10A
UAZEH05A/08A/10A
UAZEH05A/08A/10A
UAZEH05A/08A/10A/15A/20A
UAZEH05A/08A/10A/15A/20A
UAZEH05A/08A/10A/15A/20A
UAZEH05A/08A/10A/15A/20A
31-5000755 Rev. 0