Haier MVAX009ME2AA1 Installation Instructions Manual page 6

Indoor unit
Table of Contents

Advertisement

IMPORTANT SAFETY INFORMATION
WARNING
Installation and maintenance should be performed by
an authorized agency. The wrong operation of this air
condition equipment may cause water damage, electric
shock or fire.
• Please install the unit on a solid foundation or structure
strong enough to support the unit.
• The installation of this equipment should follow local
building codes.
• Use the proper size electrical wiring and secure all
terminals, organize all wiring and make sure all wiring is
not under stress. Inspect all wiring for insulation blemishes
and damage. Improper wire size may lead to fire.
• This unit is only compatible with R-410A refrigerant.
Use of any other refrigerant may lead to abnormally high
pressures and may cause damage or injury.
• Only use branches supplied by Haier. Use of any other
branches will void warranty.
• Make sure all condensate drain piping is properly trapped
when connected to building drains to avoid drawing foul
gasses into the building envelope.
CAUTION
Earth ground conductor should be connected via the
equipment disconnect to the ground buss in the breaker
panel. The earth ground conductor should not be
connected to any gas lines, water lines, lightening rods, or
telephone grounds.
• A circuit breaker should be installed. If not, it may cause
electric shocks or accidents.
Attention
Do not put any heating apparatus under the
indoor units. The heat may cause distortion
of the units.
Pay attention to the ventilation to avoid
anoxic injury
Do not place an open flame in the path of
blowing air
Do not use the unit for special purposes such
as preserving foods, works of art etc. It is an
air conditioner for comfort cooling / heating,
not a precision refrigeration system
Turn off the power to save energy if the unit
will be not used for a long period. The unit
continues to use power even though the
equipment is turned off at the controller
6
• Care should be taken to ensure that there are no
refrigerant leaks. R-410A is a heavy gas and will displace
oxygen. Ventilate the area if a leak if found.
• Keep equipment away from flammable environments.
• The drain pipe should be installed per this manual to
ensure proper drainage. The pipe should be well insulated
to avoid condensation. Inadequate installation may lead to
water damage.
• Both liquid pipe and the vapor pipe should be well
insulated. Inadequate insulation may lead to system
performance deterioration or condensate formation.
• This equipment should not be used or serviced by
personnel who have not been properly trained in its
operation and maintenance.
• Children should be supervised to ensure that they do not
play on or near the equipment.
• Keep the appliance and its power supply wiring out of
reach of children.
• This equipment is not intended to be operated by means
of an external timer or separate remote-control system
• The equipment should be checked for current leakage
after installation and power-up.
• Water or moisture may discharge from the equipment
when relative humidity rises above 80%, when condensate
drain lines become blocked or when air filters become
blocked or heavily soiled.
3-minutes protection To protect the unit, there is a
3-minute time-delay after the unit stops or after power is
applied.
Close the window to avoid outdoor air getting in. Curtains
or window shutters can be put down to avoid the sunshine.
Turn off the system and remove power when servicing the
unit.
Turn equipment off at the control before isolating power.
Please keep children away from this air conditioning
equipment.
31-5000755 Rev. 0

Advertisement

Table of Contents
loading

Table of Contents