Sealey AK4564D.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear
instruction protective
manual gloves
1. SAFETY
WARNING! Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
‰
equipment.
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
Maintain the pump station in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.
9
Use only to dispense lubricants up to SAE 150 viscosity.
9
Ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
After use, drain any fluids from the equipment before storage.
9
Dispose of waste liquids in accordance with local authority regulations.
9
Disconnect air pressure from equipment when not in use.
9
DO NOT exceed the maximum working pressure of 1500psi.
8
DO NOT point the nozzle at people or animals.
8
DO NOT use the equipment near open flames.
8
DO NOT smoke whilst using this equipment.
8
DO NOT use to extract corrosive fluids.
8
DO NOT dismantle, tamper with or adapt the gun for any purpose other than for which it is designed.
8
DO NOT use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
Keep the gun and nozzle clean and store in a safe dry, childproof location.
9
WARNING! DO NOT allow uncontrolled discharge of fluids thus polluting the environment. All liquids must be disposed of according to
‰
local authority regulations.
2. INTRODUCTION
Robust oil dispensing gun incorporating manual shut off. Fitted with rigid extension, handle lock and non-drip nozzle.
Please note that this gun is not approved for resale of oil.
3. SPECIFICATION
Model no ............................................................AK4564D.V2
Max. flow rate............................................................ 35L/min
Inlet size . ...................................................................1/2"BSP
Max. output pressure .................................................1450psi
4. ASSEMBLY
4.1. Attach the nozzle assembly to the gun.
4.2. Insert the filter into the inlet connection and then attach
the supply hose.
NOTE: DO NOT over tighten the inlet swivel connection or
damage may result.
© Jack Sealey Limited
OIL HOSE END GUN
MODEL NO:
Wear eye Wear
protection protective
clothing
Original Language Version
AK4564D.V2
AK4564D.V2 Issue: 1 15/06/21