Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1. Place the power-adapter port into the slot on the palm-rest assembly.
2. Place the power-adapter port bracket on the power-adapter port.
3. Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
Next steps
1. Install the
system
board.
2. Install the
right
I/O-board.
3. Install the battery.
4. Install the
rear
I/O-cover.
5. Install the
2230 solid-state
6. Install the
2280 solid-state
7. Install the
base
cover.
8. Follow the procedure in
Power-button assembly
Removing the power-button assembly
Prerequisites
1. Follow the procedure in
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
computer.
computer.
51