Setting The Port Security Mode; Configuration Prerequisites; Configuration Procedure - HP 3600 v2 Series Configuration Manual

To set the maximum number of secure MAC addresses allowed on a port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Set the limit of port security on
the number of MAC
addresses.

Setting the port security mode

After enabling port security, you can change the port security mode of a port only when the port is
operating in noRestrictions (the default) mode. To change the port security mode for a port in any other
mode, first use the undo port-security port-mode command to restore the default port security mode.
You can specify a port security mode when port security is disabled, but your configuration cannot take
effect.
You cannot change the port security mode of a port when online users are present.

Configuration prerequisites

Before you set a port security mode for a port, complete the following tasks:
Disable 802.1X and MAC authentication.
•
• Verify that the port does not belong to any aggregation group or service loopback group.
If you are configuring the autoLearn mode, set port security's limit on the number of MAC addresses.
•
You cannot change the setting when the port is operating in autoLearn mode.

Configuration procedure

To enable a port security mode:
Step
1. Enter system view.
2. Set an OUI value for
user authentication.
3. Enter Layer 2 Ethernet
interface view.
Command
system-view
interface interface-type
interface-number
port-security max-mac-count
count-value
Command
system-view
port-security oui oui-value index
index-value
interface interface-type
interface-number
202
Remarks
N/A
N/A
Not limited by default.
Remarks
N/A
Required for the userlogin-withoui
mode.
Not configured by default.
To set multiple OUI values, repeat this
step.
N/A