Task
Configuring a manual IPsec policy
Applying an IPsec policy to an IPv6 routing
protocol
Displaying and maintaining IPsec
To do...
Display IPsec policy information
Display IPsec proposal
information
Display IPsec SA information
Display IPsec session information
Display IPsec packet statistics
Display IPsec tunnel information
Clear SAs
Clear IPsec sessions
Clear IPsec statistics
Remarks
Required
ACLs and IPsec tunnel addresses are not needed.
Required
See Layer 3—IP Routing Configuration Guide.
Use the command...
display ipsec policy [ brief | name
policy-name [ seq-number ] ] [ | { begin |
exclude | include } regular-expression ]
display ipsec proposal [ proposal-name ]
[ | { begin | exclude | include }
regular-expression ]
display ipsec sa [ brief | policy
policy-name [ seq-number ] | remote
ip-address ] [ | { begin | exclude |
include } regular-expression ]
display ipsec session [ tunnel-id integer ]
[ | { begin | exclude | include }
regular-expression ]
display ipsec statistics [ tunnel-id
integer ] [ | { begin | exclude | include }
regular-expression ]
display ipsec tunnel [ | { begin | exclude
| include } regular-expression ]
reset ipsec sa [ parameters dest-address
protocol spi | policy policy-name
[ seq-number ] | remote ip-address ]
reset ipsec session [ tunnel-id integer ]
reset ipsec statistics
284
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
This command is supported
only in FIPS mode.
Available in any view.
Available in any view.
Available in user view.
Available in user view.
This command is supported
only in FIPS mode.
Available in user view.