Displaying And Maintaining Habp; Habp Configuration Example - HP 3600 v2 Series Configuration Manual

Step
4. Specify the VLAN to which the
HABP client belongs.

Displaying and maintaining HABP

Task
Display HABP configuration
information.
Display HABP MAC address table
entries.
Display HABP packet statistics.

HABP configuration example

Network requirements
As shown in
authentication is configured on Switch A for central authentication and management of users (Host A
through Host D).
For communication between Switch B and Switch C, enable HABP server on Switch A, enable HABP
client on Switch B and Switch C, and specify VLAN 1 for HABP packets.
Configure the HABP server to send HABP request packets to the HABP clients in VLAN 1 at an interval of
50 seconds.
Command
habp client vlan vlan-id
Command
display habp [ | { begin | exclude
| include } regular-expression ]
display habp table [ | { begin |
exclude | include }
regular-expression ]
display habp traffic [ | { begin |
exclude | include }
regular-expression ]
Figure 75, Switch A is attached with access devices Switch B and Switch C. 802.1X
235
Remarks
Optional
By default, an HABP client belongs
to VLAN 1.
The VLAN to which an HABP client
belongs must be the same as that
specified on the HABP server for
transmitting HABP packets.
Remarks
Available in any view
Available in any view
Available in any view