Table of Contents
Advertisement
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
Important Notes to the Installer
Read all instructions contained in these instal-
1.
lation instructions before installing the wall
oven.
Remove all packing material from the oven
2.
compartments before connecting the electri-
cal supply to the wall oven.
Observe all governing codes and ordinances.
3.
Be sure to leave these instructions with the
4.
consumer.
Remove oven door to facilitate installation.
5.
See Use and Care guide for instructions.
THESE OVENS ARE NOT APPROVED FOR
6.
STACKABLE OR SIDE-BY-SIDE INSTALLA-
TION.
Important Note to the Consumer
Keep these instructions with your Owner's Guide
for the local electrical inspector's use and future
reference.
IMPORTANT SAFETY
INSTRUCTIONS
•
Be sure your wall oven is installed and ground-
ed properly by a qualified installer or service
technician.
•
This wall oven must be electrically grounded in
accordance with local codes or, in their ab-
sence, with the National Electrical Code ANSI/
NFPA No.70- latest edition in United Sates, or
with CSA Standard C22.1, Canadian Electrical
Code, Part 1, in Canada.
Stepping, leaning or sitting on the
door of this wall oven can result in serious injuries
and can also cause damage to the wall oven.
•
Never use your wall oven for warming or heat-
ing the room. Prolonged use of the wall oven
without adequate ventilation can be danger-
ous.
The electrical power to the oven
must be shut off while line connections are being
made. Failure to do so could result in serious injury
or death.
1. Electrical Requirements
Each appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or fuse. To know
the circuit breaker or fuse required by your
model, see the serial plate to find the wattage
consumption and refer to table A to get the circuit
breaker or fuse amperage.
Appliance
Protection
Rating
Circuit
Watts
Recom-
240V
mended
Less than
20A
4800W
4801W -
30A
7200W
7201W -
40A or
9600W
50A
9601W
50A
and +
Observe all governing codes and local ordinances.
A 3-wire or 4-wire single phase 120/240 or
1.
120/208 Volt, 60 Hz AC only electrical supply
is required on a separate circuit fused on both
sides of the line (red and black wires). A time-
delay fuse or circuit breaker is recommended.
DO NOT fuse neutral (white wire). Only certain
cooktop models may be installed over certain
built-in electric oven models. Approved cook-
tops and built-in ovens are listed by the MFG
ID number (see the insert sheet included in the
literature package). Do not install a cooktop
over a side-by-side wall oven installation.
NOTE: Wire sizes and connections must conform
with the fuse size and rating of the appliance in
accordance with the American National Electrical
Code ANSI/NFPA No. 70-latest edition, or with
Canadian CSA Standard C22.1, Canadian Electrical
Code, Part 1, and local codes and ordinances.
An extension cord should not be
used with this appliance. Such use may result in
a fire, electrical shock, or other personal injury. If
you need a longer power cord you can purchase
a 10' (3 m) power cord kit by calling the Service
Center.
3
Appliance
Protection
Rating
Circuit
Watts
Recommend-
208V
ed
Less
20A
than
4100W
4101W -
30A
6200W
6201W -
40A or 50A
8300W
8301W
50A
and +
Table A
Advertisement
Table of Contents
