Installing The Optional Type-C Module - Dell OptiPlex Micro 7010 Owner's Manual

Steps
1. Remove the two (M2x3) screws that secure the optional Type-C module.
2. Remove the optional Type-C module from its slot on the chassis.
3. Lift and hold the optional Type-C module in place above the system board.
4. Disconnect the Type-C DisplayPort cable from the system board.
5. Disconnect the Type-C USB cable from the system board.
6. Disconnect the Type-C power cable from the system board.
7. Disconnect the Type-C signal cable from the system board.
8. Remove the optional Type-C module from the computer.

Installing the optional Type-C module

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
62 Removing and installing Field Replaceable Units (FRUs)