D-Link DSA-3100 Owner's Manual page 40

Using the Configuration Utility (continued)
In this example, if
you want the
192.168.202.0/24
and 192.168.100.0/
24 network to have
access to each other,
you should add a
static route in the
DSA-3100 and also
in the
192.168.200.253 IP
router. The following
settings show the
DSA-3100's static
route configurations.
Destination
Network ID:
Destination Subnet
Mask:
Gateway IP
Address:
Click Apply:
Note: For the static route to work, the next hop route must also have added a static
route to forward all 192.168.100.0/24 IP packets to the DSA-3100. After clicking the
Apply button, you will see the added route is shown in the current running routing
table. Click " View Routing table " to verify.
Every change to the static route settings must be stored by
using the Save Setting function, and restarting the DSA-3100.
Advanced > Static Route
Specifies the target network or host IP. In this example we
use network 192.168.202.0 as the routed target.
Specifies the target subnet mask. In the example, we use the
subnet mask 255.255.255.0.
Specifies the IP address of the next hop router. In the
example, we set this to 192.168.0.253 as the 192.168.202.0
network is behind the router.
Always click Apply to save the changes/additions.
40