Error Messages - Sharp MS702 - MiniDisc Recorder Operation Manual

ERROR MESSAGES

Error messages Meaning
The battery has run down.
BATT EMPTY
Nothing is recorded.
BLANK DISC
No copy can be made because of
Can't COPY
the SCMS copyright system.
A track cannot be edited.
Can't EDIT
Recording cannot be performed
Can't REC correctly due to vibration or shock
in the unit.
Can't WRITE Editing is impossible.
The disc is scratched.
DEFECT
Din UNLOCK Poor connection of the digital cable.
DISC ERROR The disc is damaged.
The disc is out of recording space.
DISC FULL
The unit is in the safety mode.
HOLD
LOCKED The EJECT lever was moved
LOCK ERROR during recording or editing.
NO DISC A disc has not been loaded.
The disc is write protected.
PB DISC
You tried to record on a playback-
PROTECTED
only disc.
Improper power is being supplied.
POWER ?
Since a track number is currently
SORRY being located or written to, the unit
cannot accept your command.
The unit is malfunctioning and will
SYSTEM ERR
require service.
The temperature is too high.
TEMP OVER
A large portion of the disc has been
TOC ERROR
damaged.
There is no space left for recording
TOC FULL
character information (track names,
disc names, etc.).
The track has been protected from
Tr. Protect
being erased.
A large portion of the disc has been
damaged.
U TOC ERROR
There is an error in the recorded
signal.
A disc which contains data other
than music was played.
? DISC
There is an error in the signal from
the disc.
Remedy
Charge the rechargeable battery or
replace the alkaline batteries (or use
the AC adaptor for power).
Replace the disc with a recorded
disc.
Record using the analog cable.
Change the stop position of the
track and then try editing it.
Re-record or replace it with another
recordable disc.
Check the number of tracks.
If the sound you hear is not correct,
try recording again.
Replace the disc with another
recordable disc.
Connect the digital cable securely.
Reload the disc or replace it.
Replace it with another recordable
disc.
Return the HOLD switch to its
original position.
Turn off the power and remove the
MiniDisc.
Load a disc.
Move the write protection knob
back to its original position.
Replace it with a recordable disc.
Use one of the specified power
sources.
Wait and then try the operation
again.
For service, contact your local
Sharp authorized service center.
Turn off the power, and wait for the
unit to cool.
Replace it with another recorded
disc.
Replace it with another recordable
disc.
Edit the track with the device on
which it was recorded.
Replace it with another recorded
disc.
Erase all of the signal errors, and
then try recording again.
A disc which contains non-music
data cannot be played.
Replace it with another recorded
disc.
39
MD-MS702