4.1 Troubleshooting
Error Code
Error Message
023
System data file
version error
024
System initialization
file version error
025
Card initialization file
version error
026
LCD file version error
027
System data file
checksum error
028
System initialization
file checksum error
029
Card initialization file
checksum error
030
LCD file checksum
error
031*
System data file not
found
032*
System initialization
file not found
033*
Card initialization file
not found
034*
LCD file not found
035
System data file
access error
036*
System initialization
file access error
037*
Card initialization file
access error
038*
LCD file access error
039*
SD file access error
090
Over Card Limitation •
091*
PT connection over
092*
CS connection over
200
LPR start up error
(ROM NG)
201*
LPR start up error
(RAM NG)
234
Installation Manual
PROBABLE CAUSE
•
Old system files on SD
Memory Card
•
Defective system files on
SD Memory Card
•
SD Memory Card not
installed
•
Bad connection of SD
Memory Card
•
SD Memory Card
malfunction
•
MPR card malfunction
Too many optional service
cards installed
•
Too many PTs connected •
•
Too many CSs connected •
•
Optional service card
malfunction: DHLC, DLC,
CSIF, T1, E1, BRI, PRI,
OPB3, CTI-LINK, E&M,
IP-GW, DID, SLC8
SOLUTION
•
Restore the backup files
•
Re-install the software
•
Press the Reset Button
•
Reprogramme the Hybrid IP-PBX
•
Replace the SD Memory Card
•
Replace the MPR card (be sure to turn
off the Hybrid IP-PBX when replacing)
•
Reduce the number of optional service
cards
Reduce the number of PTs
Reduce the number of CSs
•
Pull out and re-insert the
corresponding optional service card
•
Press the Reset Button
•
Replace the corresponding optional
service card