Brother MFC-255CW Network Manual page 109

Control panel setup
For Touchscreen models
a
Press MENU.
b
Press Network.
c
(For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d
Press TCP/IP.
e
Press Gateway.
f
Enter the Gateway address.
Press OK.
g
Press Stop/Exit.
Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRNxxxxxxxxxxxx for a wired network or BRWxxxxxxxxxxxx for a wireless network (where xxxxxxxxxxxx is
your machine's Ethernet address) (up to 15 characters).
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
For DCP-373CW, DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW and
MFC-495CW
(For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose Node Name.
Press OK.
f
Enter the Node Name.
Press OK.
Note
DCP models cannot change the Node Name from the control panel menu. You can change the Node
Name using BRAdmin Light or BRAdmin Professional 3.
g
Press Stop/Exit.
6
6
6
100