Manual Setting - Canon imageCLASS D1120 User Manual

4 Set Up Network Connection
The display returns to the standby mode:
●
The machine may enter the standby mode (Auto Clear function) while you are
setting it up. Make the setting again from the main menu.
The display turned OFF:
●
The machine may enter the Sleep mode while you are performing setup. Press
[Energy Saver] to turn the display back ON and continue the setup.
1
Press [Menu].
2
Press or to select <10. SYSTEM
SETTINGS>, then press [OK].
M E N U
1 0 . S Y S T E M
3
Press or to select <5. NETWORK
SETTINGS>, then press [OK].
S Y S T E M S E T T I N G S
5 . N E T W O R K
4
Press or to select <1. TCP/IP
SETTINGS>, then press [OK].
N E T W O R K S E T T I N G S
1 . T C P / I P
5
Press or to select <3. VIEW IP
ADDRESS>, then press [OK].
T C P / I P S E T T I N G S
3 . V I E W I P

Manual Setting

This is the setting for the Static IP. If the machine obtains IP address automatically in "Automatic Setting, "
skip this setting.
In this setting, you enter the IP address, subnet mask, gateway address manually.
<10. SYSTEM SETTINGS> → <5. NETWORK SETTINGS> → <1. TCP/IP SETTINGS> → <1. IP ADDRESS AUTO> →
<OFF> → <2. REG. IP ADDRESS> → <1. IP ADDRESS> → Enter the IP address → <2. SUBNET MASK> → Enter
the subnet mask → <3. GATEWAY ADDRESS> → Enter the gateway address → Press
OFF the main power → Restart the machine.
For details on this setting, see "Network Settings, " in the e-Manual. Once you complete the setting, go to
"Check IP Address Setting, " on p. 17.
18
S E T T I N G S
S E T T I N G S
S E T T I N G S
A D D R E S S
6
Press or to select <1. IP ADDRESS>, <2.
SUBNET MASK>, or <3. GATEWAY ADDRESS>,
then press [OK].
V I E W I P A D D R E S S
1 . I P A D D R E S S
If the machine is communicating to the network properly,
the IP address, subnet mask and gateway address are
displayed.
If not, IP address, subnet mask and gateway address are
not displayed.
If the machine does not get the IP address after you
connect the LAN cable, turn OFF the main power switch
once, and then turn it ON again and wait for 90 seconds. If
the machine still does not get the IP address, ask your
network administrator.
It is recommended that you take a note of the IP address
you confirmed here, because you need it for using the
Remote UI.
7
Press [Stop/Reset] to return to the standby
mode.
If the IP address, subnet mask, and gateway address are
not displayed, the machine is not communicating with the
network. Check the setting of the IP address.
[Menu] →
[Stop/Reset] → Turn